Enclosure Features

• NEMA 12 enclosure fabricated from 14 ga. galvanized steel or 14 ga. T-304 stainless includes integral drip shield for protection against rain and snow.
• Continuous hinge design provides easy access to breakers and selector switch.
• Hasp and staple are provided for padlocking
• Standard Size is 36"H x 14-1/2"W x 7-3/8"D (914mm x 368mm x 187mm) to provide ample space for wiring requirements.
• Mounting tabs on top and bottom of enclosure.
• Accepts incoming power from 120/240 VAC single phase source.

Load Center Features

• Factory installed 2-pole main breaker with 70 Amp or 100 Amp continuous rating. Factory installed branch breaker for lighting control circuitry with 20 Amp continuous rating.
• Ample space for adding plug-in breakers. Available space for installing up to 13 single pole breakers or 6 double pole breakers.
• Branch breakers available in single or double pole up to 70 Amps.
• Rated for 120/240 Volts AC, single phase, 3-wire with neutral and grounding provisions.
• Incoming power is fed through main breaker via mechanical solderless type lugs approved for Cu or Al conductors. Lugs accept incoming wire sizes from #4 through #2/0.
• "Dead-Front" trim for personnel protection.
• One piece plated copper bus.
• 22,000 RMS sym. Amperes short circuit current rating.
• Accepts Square D "QO&" series plug-in branch circuit breakers.
• NEMA 1 Enclosed Lightning Arrestor pre-wired ahead of Load Center  

Lighting Control

• Photocell with twist-lock mounting base
• 20 Amp, 2-pole breaker for circuit protection
• 30 Amp NEMA Rated Lighting Contactor w/ 120 VAC Coil (20 Amp Tungsten Lighting Rating)
• Separate Dead Front for Lighting Control Section
• H-O-A Selector Switch for Lighting Control Operation
• Separate 10 Amp Breaker for Control Circuitry
• Plexiglass photocell viewing ports on both sides of enclosure
• Termination points for up to 10 pairs of #12 awg lighting control wires.

Applicable Standards

All SLC II Main Breaker Load Centers with Lighting Control meet or exceed the following standards:

• NEC
• Federal Specifications WP-115c, Type 1, Class 2
• UL 508 and UL Service Entrance Equipment